Linuxstamp II 8-channel RC Control board

From OpenCircuits
Revision as of 23:48, 23 February 2011 by Linuxvolts (talk | contribs)
Jump to navigation Jump to search

Servo ls2 small.JPG Linux boebot chasis.JPG

Description

This board can control up to 8 RC servos via the onboard Pololu chip. A simple serial line from the Linuxstamp II controls the Pololu chip. There is also a prototyping area with access to power as well as UART, SPI, I2C & GPIO lines from the Linuxstamp II.

Status

You can get a board from [1].

Power supply

There are two options for the poser supply. Most of the time a 1.5A linear regulator from ST should be fine (digikey p/n 497-3468-1-ND). However if more current is needed a switching power supply from Recom can be used (digikey p/n 945-1028-ND).

License

All files for this project are licensed under the GNU GPL V2

Hardware design files

Warning!!! Use this design at your own risk. You can find the design files here.

Demo programs

There are 2 demo programs that can be found here.

Mounting

The mounting holes on the board are designed to match the boebot Chassis. So the board can be used with continuous rotation servos to make a little rover.