GM862 SMD Connector
Error creating thumbnail: Unable to save thumbnail to destination
This is the Molex SMD connector that interfaces to the GM862 Cellular Modules. If you're prototyping with the GM862, you pretty much have to have one of these. Watch out, it's 0.5mm pitch, 50-pin, SMD connector. You can solder it by hand, but you'll need some experience, solder wick, and a decent iron. You can also reflow it with a hot-plate and a stencil. If you're not comfortable soldering it, there are breakout boards and designs available from SFE.
Molex Connector Footprint and Spec Sheet
Take a look at the SFE Footprint Library
FP Name: GM862
The dimension stuff can be found on page x of the hardware datasheet.
Molex part # : 53748-0504
GM862 Cellular Module
Original Creator: --Sparkfun 12:08, 26 January 2006 (PST)