Editing Raspberry Pi Mounting Platform and Bracket

Jump to navigation Jump to search

Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.

The edit can be undone. Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.

Latest revision Your text
Line 85: Line 85:
 
* I have found that 50% infill is strong enough.
 
* I have found that 50% infill is strong enough.
 
* So far I have used PLA.  Should work in anything you can print  
 
* So far I have used PLA.  Should work in anything you can print  
 
= Enhancements I May Make =
 
 
* Add Pi Zero
 
* Mount the Pi itself, with more options than the current bracket
 
* More adapters to put on the platform
 
  
  
  
 
[[Category:Arduino/RaspberryPi]] [[Category:FreeCad]] [[Category:CAD/3DPrint]]
 
[[Category:Arduino/RaspberryPi]] [[Category:FreeCad]] [[Category:CAD/3DPrint]]

Please note that all contributions to OpenCircuits may be edited, altered, or removed by other contributors. If you do not want your writing to be edited mercilessly, then do not submit it here.
You are also promising us that you wrote this yourself, or copied it from a public domain or similar free resource (see OpenCircuits:Copyrights for details). Do not submit copyrighted work without permission!

Cancel Editing help (opens in new window)