Difference between revisions of "Manhattan style"

From OpenCircuits
Jump to navigation Jump to search
 
(brief summary)
Line 1: Line 1:
 +
'''Manhattan style'''
 +
is one popular way to build ham radio electronics.
 +
It involves small "pads", typically circular dots roughly 3 mm diameter punched out of plain copper-clad board.
 +
 +
The pads are super-glued onto the "substrate", a large copper-clad board.
 +
Each component is mounted right-side-up by soldering its pins to pads.
 +
 +
The builders try to make each pad represent one node in the schematic -- every pin that connects to that node is soldered to one pad, when possible.
 +
When it's not possible, hook-up wire is used to connect pad-to-pad and pad-to-DIP-socket-pin.
 +
 +
Each ground pin of a component is soldered directly to the substrate.
 +
 +
K7QO has an excellent description of the technique:
 
http://www.k7qo.net/manhattan.pdf
 
http://www.k7qo.net/manhattan.pdf
 +
 +
''(FIXME: put a photograph here)''
 +
 +
----

Revision as of 07:39, 12 June 2007

Manhattan style is one popular way to build ham radio electronics. It involves small "pads", typically circular dots roughly 3 mm diameter punched out of plain copper-clad board.

The pads are super-glued onto the "substrate", a large copper-clad board. Each component is mounted right-side-up by soldering its pins to pads.

The builders try to make each pad represent one node in the schematic -- every pin that connects to that node is soldered to one pad, when possible. When it's not possible, hook-up wire is used to connect pad-to-pad and pad-to-DIP-socket-pin.

Each ground pin of a component is soldered directly to the substrate.

K7QO has an excellent description of the technique: http://www.k7qo.net/manhattan.pdf

(FIXME: put a photograph here)