Difference between revisions of "Linuxstamp"

From OpenCircuits
Jump to navigation Jump to search
Line 10: Line 10:
 
* 1x SD card slot
 
* 1x SD card slot
 
* Serial debug port access through FTDI USB/Serial converter
 
* Serial debug port access through FTDI USB/Serial converter
 +
* JTAG port
 
* 2-Layer PCB design
 
* 2-Layer PCB design
  

Revision as of 23:20, 18 April 2007

Description

The Linuxstamp is designed to be a general purpose processor module. It is designed to work as a stand alone module (SD card, ethernet and USB/Serial converter are all on the module). This allows all initial development to be done without a motherboard, but for integration into a specific project a motherboard with specific features could be designed.

Features

  • Atmel AT91RM9200 processor (Arm9 processor with MMU)
  • 32Mb SDRAM (Only limited by 1x 54-TSOP SDRAM chip)
  • 8Mb SPI Dataflash
  • 1x 10/100 Ethernet
  • 1x USB host port
  • 1x SD card slot
  • Serial debug port access through FTDI USB/Serial converter
  • JTAG port
  • 2-Layer PCB design

Licence

All files for this project are licensed under the GNU GPL V2

Project files

Status

Links

Pricing

The parts cost for qty 1 is $75 from digikey, and $55 for qty 100
I'm sure this can be greatly reduced with higher quantity
We will make a small run soon, and I will let you know when these are available

discussion

Can I plug a USB peripheral into the Linuxstamp, such as a USB Wifi adapter? --DavidCary 22:02, 17 April 2007 (PDT)
Yes, any USB device that is supported by the kernel should work with the Linuxstamp. --Linuxvolts 23:15, 18 April 2007 (PDT)