Difference between revisions of "Linuxstamp"
| Line 26: | Line 26: | ||
*[http://atmel.com/dyn/products/product_card.asp?part_id=2983 Atmel]: AT91RM9200 info on Atmel's site | *[http://atmel.com/dyn/products/product_card.asp?part_id=2983 Atmel]: AT91RM9200 info on Atmel's site | ||
*[http://maxim.org.za/at91_26.html]: Up to date kernel patch | *[http://maxim.org.za/at91_26.html]: Up to date kernel patch | ||
| + | *[http://cadsoft.de/ Cadsoft.de]: Free (as in beer) tools for schematic and PCB design | ||
== Pricing == | == Pricing == | ||
Revision as of 19:26, 17 April 2007
Description
The Linuxstamp is designed to be a general purpose processor module. It is designed to work as a stand alone module (SD card, ethernet and USB/Serial converter are all on the module). This allows all initial development to be done without a motherboard, but for integration into a specific project a motherboard with specific features could be designed.
Features
-Atmel AT91RM9200 processor (Arm9 processor with MMU)
-32Mb SDRAM (Only limited by 1x 54-TSOP SDRAM chip)
-8Mb SPI Dataflash
-1x 10/100 Ethernet
-1x USB host port
-1x SD card slot
-Serial debug port access through FTDI USB/Serial converter
-2-Layer PCB design
Licence
All files for this project are licensed under the GNU GPL V2
Project files
PCB Top view (pdf)
PCB Bottom view (pdf)
Schematic (pdf)
Status
Links
- Atmel: AT91RM9200 info on Atmel's site
- [1]: Up to date kernel patch
- Cadsoft.de: Free (as in beer) tools for schematic and PCB design
Pricing
The parts cost for qty 1 is $75 from digikey, and $55 for qty 100
I'm sure this can be greatly reduced with higher quantity
We will make a small run soon, and I will let you know when these are available
