Tools and Techniques

From OpenCircuits
Revision as of 18:19, 13 September 2010 by DavidCary (talk | contribs) (link to more specific article)
Jump to navigation Jump to search

This is the beginning of a page to reorganize Techniques and to include both software and hardware tools and to perhaps distinguish, design, debuggin and building tools. Just an idea for now not linked into the wiki.


Software design tools

For software design tools such as Design CAD CAM

CAD/CAM

Circuit Schematics / Schematic Capture

= Circuit simulation , see software tool.


Micprocessor Design/Programming

Assemblers / Compilers

Assemblers let you program in the basic instructions of the chip, compilers work at a higher, more abstract level which is then transated into the basic chip insturctions. In principal an assembler can result in better programs, if the programmer is good enough and spends enough time. Compilers make it easier to move programs from chip to chip. For a discussion of the advantages of a compiler for the PIC see Use C for PIC Programming!

For the PIC compilers see PIC Links#Compiler Section

Simulators

Simulators are often included with an assembler or compiler, there are also from freestanding ones.

Features to look for.

  • Comming

Calculations

Do not for get the good old spreadsheet, do your own thing, or you may find ones for download that have been set up for specific calculations.


Design Manual - Non Cad Cam

Construction

Tools ( may also be useful for Debugging )

Hardware tools

A directory of hardware tools that you may find useful.


Debugging/Test Instruments

Common Hand Tools Soldering Iron


Test Equipment

Oscilliscopes Logic Anilizers Signal Generators Multimeters Power Meters

Microcontroller Programmers In Circuit Serial Bootloaders


Debugging

InCircuit Debugging

Misc Tips Tricks

Misc Tips Tricks


PC Sound Card Based Test Instruments

The sound card on a PC cna be used either to capture signals or to generate them. Normally it is limited to acting in the audio range, about 20 Hz to 20 K Hz. You cna do this without any additional hardware, or extend the capabalities with some external hardware. This gives you a simple way to get Oscilliscopes, signal generators, and signal analizers. Below are some links, you can probably find more ( and post them here please ). This is not to be confused with instruments that are PC based, but are highly dependent on external hardware ( we should have a section on them sometime soon ).


Oscilliscope

Signal Generator

At http://www.slatecreekengineering.com/SoundArb.htm

SoundArb is a free program from David Sherman Engineering Co. that allows you to control a PC sound card like you would a conventional function generator. You can select standard waveforms, load arbitrary waveforms from a text wave table file, control the frequency and amplitude of the waveform, and select from a versatile set of triggering modes. With a stereo sound card, one channel can be used as a "sync" output.


At http://www.epanorama.net/links/pc_sound.html scroll down to: heading "Signal generator software"

Signal Analizers

also heading on:

Signal waveform analyzing tools


also heading on

FFT spectrum analyzer programs