Other Passives

From OpenCircuits
Revision as of 13:21, 28 January 2009 by Russ hensel (talk | contribs)
Jump to navigation Jump to search

This article is being split into components check for duplication prior to updataing

Inductors

An inductor reacts to current, but not to its value, but rather its change. It “tries” to keep the current through it constant. Any change in current causes a voltage across the inductor. The key equation for an inductor ( it is a bit complicated, but anyway here it ) is:

equation here soon

where L = inductance ( units: henry ) V = voltage ( unit: volts ) I = current ( unit: Ampere ) t = time ( unit: seconds )

Uses:

  • tuned circuits: a circuit that responds in a special way to some frequencies( s ).
  • power supply filter: remove the pulsing DC left from rectification or other noise in the signal.
  • Decoupling: usually blocking high frequencies from one part of a circuit from getting in another part.
  • boost buck regulators: voltage regulators that decrease or increase voltage.

Links

Comments:

"Ferrites? I don't know much about 'em, I only use ferrites in switching regulators." --National Semiconductor's Bob Pease

Can be replaced in many circumstances with an impedance inverter using only an opamp, a capacitor, and a few resistors.